Unscrew and remove the edge plate screws from the trim around the bolt with a philips screwdriver if reversing a deadbolt lock.
How to remove house door lock.
Step 3 pull the doorknobs or lock trim apart and out of the door panel.
The main point of this action is to place enough force on.
Pull the trim and bolt from the door edge and set aside.
These screws are usually phillips head screws and hold the two.
Remove these screws if your door knob has visible screws your job will be easy.
Removing a door knob with visible screws step 1.
Open the door and look for the latch plate along the door s edge.
This was a keyed door lever lock but i mention how to do the same with the sta.
Outswing doors have outward.
Grab that phillips head.
One night after getting ready for bed a person walks up to the main door of his house to lock it and pulling up on the handle he feels and almost hears the slight almost imperceptible resistance in the german manufactured locking mechanism of the latch.
Scratch awl or similar pointy tool.
1 8 3mm drill bit.
Scratch awl or similar pointy tool.
Ramming a door will likely lead a damaged door and door lock.
Use a thin flat screwdriver to pry off the round decorative plate also sometimes referred to as a rose to reveal the lockset mounting screws.
This is showing how you can get your lock apart when you don t see any screws.
Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it.
How to remove cylinder door locks 1.
Unscrew and finish use a drill driver to remove the longer mounting screws.
Unscrew this plate and remove the latch from the door if possible.
Unscrew and remove the two screws from the door lock.
Remove the lock from the door with a screwdriver and take it to your local hardware store or key shop where the technician can rekey it for you for 5 to 10.
This causes the doorknob to separate inside and both sides can be removed from the door.
3 32 2 4mm drill bit.
Look for a small set screw at the base of the handle.
Remove this screw using a drill or screwdriver.