How To Remove Rear Door Panel On 2004 Chevy Suburban

Remove the door panel using the common screwdriver.

How to remove rear door panel on 2004 chevy suburban.

Remove the door handle bezel. Remove the trim panel from the door carefully sliding the trim panel up to release the retainers from the door. Slide the screwdriver down until it contacts the snap and pry the snap out of the recess in the door. Remove the trim panel upper extension.

Moving the whole horizontal control up or down. Remove door lock solenoid and plug it into another door to see if it works 2. There are snaps on all three sides of the panel. Remove the power accessory switch panel.

Remove the speaker wire. Also look on side of door for possible child saftey lock switch. Remove the courtesy light remove door panel screws. If you can reach inside the door to the final mechanism that everything pushes on push it yourself to see if it works 3.

Remove the trim panel screws. Pull drivers rear door panel off 1. Hello here is the instructions for removing the door panel. Hey everyone today s video is a quick lesson on how to remove the door panels on a 2000 2006 nbs chevy suburban tahoe silverado also gmc yukon xl cadilla.

Raise or lower the rear of the seat cushion by raising or lowering the rear edge of the horizontal control. Remove the window handle. Do the same to all the snaps. My 2003 chevy suburban door locks for the 2 rear doors and the tail gate door do not work properly.

Place the common screwdriver at the top of the panel in between the door panel and the door.